Article Written By: RebbecaMyers
Garage door openers installation instructions will vary depending on the type of door that you select. There are three types of garage door openers. These are the chain driven, belt driven, and screw driven openers. The difference in the openers is mainly in the mechanism that is attached to the door.When you are selecting the garage door opener to install, you will want to make sure that it meets the needs and requirements of your home. The options and features found on openers can differ greatly and it will be important that you have the kind of opener that will provide you with several years of service.Getting an opener that is durable and has been designed with all of the safety features available will help to make sure that no accidents occur. Most openers have an automatic reverse feature or infrared beam that stops the door when there is an obstruction. With the infrared beam, the door stops when anything crosses the beam.Installing the door is very easy and can be accomplished in as little as one afternoon. The motors of the openers usually have a 1/3 to 1/2hp motor that powers the door opener. However, it is the chain, belt, or screws that hold the weight of the door. If you are installing a chain driven door, you will want to be sure that you use an industrial strength chain.The installation will not require any special tools. One of the important tools needed will be a level. The opener will function improperly if it is not level when installed. When the weight is shifted there is more pressure put on one side of the pulley than the other which causes uneven wear on the equipment.Some openers are attached to a steel T-bar that must be installed against the rafter beams prior to installing the opener. Other openers are attached to reinforced beams. The motor assembly must be attached securely to the beam because it vibrates when used. When there is no beam to attach the assembly, a secure metal bracket just be attached to the roof in order to suspend the assembly securely from the ceiling.The opener assembly must be at least seven feet off the ground in order to work effectively. The remote control of the opener on some models are reset from the motor housing. Other models have automatic resets that change the code each time the control is used. This keeps the remote from being easily over-ridden by other electronic devices.When installing the infrared box on the garage door it is important that it be sat at a height where the beam will be broken by the smallest animal you have that might pass under the door. When the opener include an infrared beam, the door will automatically stop when the beam is broken. Most doors also come with an auto reverse feature, where it will stop if it meets an obstruction when it is closing.After selecting the opener that you are going to use, it will be very important to read the manufacturers garage door openers installation manually carefully and follow the instructions to assure that the door will work well and provide the level of safety required for your home.
This Article Has Been Published on Mon, 14 Dec 2009 and Read 251 Times