At the top of the cymbal stand, you'll see what's called the cymbal tilter. The tilter may or may not be in a folded up position when you first go to set it up. You'll know it's in the folded up position if you're looking at it and you can't picture a cymbal being attached to it. In this case, simply unscrew the hand screw that you'll find on the side of the tilter just enough so you can move the tilter up and down. Put the tilter in a more or less horizontal position, and use the same hand screw to tighten it in place. When the tilter is in its upright position, you should see either a metal wing nut or a plastic sleeve, two felts, and a metal disc, all stacked up on each other on the tilter.
To put the cymbal on the stand, unscrew the wing nut or sleeve ail the way and put it aside (but not too far aside because you're going to need it again in a second). Next, take one of the two felts off the tilter and place the cymbal right side up on the stand on top of the remaining felt. Then, take the first felt and put it on top of the cymbal. Now, take the wing nut or sleeve and screw it on top of the tilter. When screwing down the wing nut on top of the cymbal stand, be careful not to screw it down so tightly that the cymbal barely moves when it's on the stand. You want the cymbal to have as much movement on the stand as it can without failing off.
If you put the death grip on the wing nut, you run the risk of breaking your cymbals by not allowing them free motion when they're being played. Now that the crash cymbal is on its stand, you can put it n your setup. As a general rule, most drum kits have only one set of hi hat cymbals and one ride cymbal, but they can have any number of crash cymbals. For example, my setup has three different crash cymbals in various places. if you have only one crash cymbal at this time, the best place to put it would be between the hi hats and the first tom.
The crash cymbal is made to be hit on its edge, so you should put it at a more or less horizontal position. Put it at a height that's comfortable for you and the length of your arms. Be careful not to put it up so high that you need to stretch your arm all the way to hit it, and don't put it low enough to knock against the top of your hi hat stand or your first tom when it's in free motion after being hit. Think of the height that Goldilocks would like: just right. The Ride Cymbal The ride cymbal is most likely the largest and heaviest cymbal in your collection. Go ahead and put it on a cymbal stand the same way that you put your crash cymbal on its stand, with one felt under the cymbal and one felt and the wing nut on top of the cymbal. You might want to tighten down the wing nut just a little bit more than you did with the crash cymbal, but again, not too much.

Add Your Picture

Article Submitted By: ronblack
This Article Has Been Read 257 Times

---

Remember: The article body, title, author bio and links may not be changed or removed. By publishing this article, you agree to all the terms in our Terms of Service.
Get the HTML for reprinting the article to your site

Rating: Not yet rated

--Choose-- 0 1 2 3 4 5

Information about new music forms : available over the internet

Booking your Wedding DJ

Profitable deals for buying DJ equipment

Guitar Lessons For Beginners Come In A Discrepancy Of Forms

Book your Wedding DJ with Confidence

Acoustic Guitar Body Basics

Are You Taking The Right Instructions To Play Guitar For Novice?

Guitar Lessons And Methods To Get The Most Help From Them

Learn To Play Guitar Songs By Taking A Few Quick Tips

How The Headsets Will Help You To Improve Your Productivity

Learn Guitar Scales : The Mixolydian Solos

How you can duplicate cds

Checklist for your Wedding Band or Singer

Key Factors To Take into Account When Looking For Acoustic Guitar Strings

Find Wedding Entertainers Online

---